Question: What is an Isolation Transformer?
Answer: An isolation transformer is used in transmission and distribution systems to maintain stable voltage and current levels. In this type of transformer, the number of turns in the primary and secondary coils is equal, which prevents any excess voltage or current from flowing through.
- Same number of turns
- Same power
- Same voltage
- Same current
- Np : Ns = 1
2. What is an Auto-Transformer?
Answer: An auto-transformer is a type of transformer that can step down an over-voltage and subsequently step it back up or restore it to its operational level.
- It utilizes a single-winding .(dot) conversion method.
- It requires a smaller amount of copper.
- It offers high efficiency.
IH = IL + DC (where DC = terminal current)
DC = IH - IL (Given: I1 = IH, I2 = IH - IL, V2 = VL)
Load Power (PL) = VL * IL = VL * (IL - IH + IH) = VL(IL - IH) + VL * IH (where VL * IH = conductive power)
3. What is a single-phase transformer under load?
In the transformer shown in the figure, a flux, denoted as Ø1, is generated in section AB, with its direction being AB→.
Additionally, a flux, denoted as Ø2 is generated in section CD due to the load current, with its direction being CD→.
Since the presence of Ø2 causes the value of Ø1 to decrease, the current I1 on the primary side is increased to maintain the original level of Ø1, thereby restoring its value.
Let Ø1 + Ø be a flux component directed along AB→, and let Ø2 be a flux component directed along CD→ that is, in the direction opposite to AB→.
Now, if Ø = Ø2, then the total flux flowing through the transformer is Ø1 + Ø - Ø2 = Ø1.
In other words, the magnitude of the flux remains constant at all times. This is how a transformer operates under load conditions.
4. What is Single phase No Load Condition Transformer?
Given in Fig
I0 = No Load Current
Im = Magnetising Current
Iw = Working Component --> (Copper Loss & Core Loss)
Ø = Magnetic Flux
E1 & E2 = EMF = Electro Motive Force.
Power factor = CosØ0 = Iw / I0
Iw = I0 cosØ0
Im = I0 sinØ0
I0 = (Iw² + Im²)¹/²
Im and Ø are in the same phase; Ø > Im
Iw and V1 are in the same phase; V1 > Iw
